Question
I am running a SM AS-2115HS-TNR based cluster with ESXi 8.0.3. I need to enable secure boot on all these host.
Do you have document on how to enable them?
Print
Answer
Our SecureBoot setup procedure is same for AMD and Intel platforms.

Steps:
1) Reset system and press DEL key to get into BIOS and go to “Security” tab
2) Change CSM support from “Enabled” to “Disabled”, then press F4 to save & exit BIOS.
3) Press DEL key again to get back into BIOS and go to Key Management. 
4) Enable Provision Factory Defaults, press Y to proceed.
5) Press ESC to go back to Security page and enabled Secure Boot.  Press F4 to save & exit to complete the setup.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
D B 7 R
FAQ ID:
44397
Related Category / Keyword:
N/A
Date Posted:
12/12/25
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region